Imetec R5301 Instructions Pour L'utilisateur page 24

you are advised to use the Anti-dust mite program once a week. For the double bed model,
the program must be selected for both sides of the bed simultaneously. For the anti-dust mite
treatment to be effective, keep the bed covered with a blanket or duvet.
EN
To select the Anti-dust mite program, press the Program selector button (6); the Anti-dust
mite program LED (14) will light up and the Temperature LED (8) will display the letter H. For
the double bed model, repeat the same operation on both control devices. After 6 hours,
the sanitising program will end automatically and the control device will switch off. If the
temperature or timer is modified while the Anti-dust mite program is active, the program will
be interrupted and the control device will begin working with the new settings.
WARNING!
mite function. If the appliance is used with the control device set at a
higher temperature than the one recommended for night-time or
continuous use, the user may be at risk of burns or heat stroke.
Wake Up program
The Wake Up program gives you the ideal temperature when you wake up, automatically
adapting the temperature level during the last sleep phase to ensure a pleasant feeling when
you wake up. To activate this program, proceed as follows:
• Switch on the control device manually or remotely
• Activate the Wake Up program manually or via the Alexa app or voice command
• Select the required temperature from levels 0 - 5. If level 0 is set, the appliance will not warm
up during the night but will switch on automatically about half an hour before your wake-up.
• Select the required timer (4 - 12 hours).
The Wake Up program only works with the temperature set at a level between 0 and 5, and
with the timer set at a value between 4 and 12 hours.
At the end of the selected timer, the control device switches off automatically.
Comfort program
The Comfort program is conceived not only for the night but even for a moment of afternoon
relaxation. It gives you the ideal temperature for 3 hours, letting you recharge your own
batteries with a regenerating rest.
The Comfort program can be selected directly via the Alexa app or voice command, or by
pressing the Program selector button (6); the Comfort program LED (12) will light up. Once 3
hours have elapsed since the launch of the program, the control
device will switch off automatically. If the temperature or timer is modified while the Comfort
program is active, the program will be interrupted and the control device will begin working
with the new settings.
23
DO NOT get into the bed with the appliance set to the anti-