Automatic Shutdown; Cleaning And Maintenance; Before Washing - Imetec TERMOFORO Instructions D'utilisation

AUTOMATIC SHUTDOWN

• The heating pad will provide a 3 hour heat treatment, then it will
automatically shut off. The standby led (2) will light up after the 3
EN
hours of operating to indicate that the product has switched off
automatically.
• To switch the appliance back on by pressing the ON/OFF selector
(4) twice and select the desired temperature once again.
SWITCH-OFF
• Switch the heating pad off by pressing the ON/OFF selector (4) when
it is no longer used.
• Remove the plug from the mains socket.
The heating pad and the cover (MOD.1 only) can be washed. Refer to
the washing symbols on the product and cover labels for the washing
instructions.
WARNING! Always disconnect the appliance from the
mains and disconnect the control connector from the
appliance before cleaning or performing maintenance.

BEFORE WASHING

• Disconnect the power cable from the socket.
• Remove the heating pad from the cover (MOD.1 only).
• Disconnect the heating pad connector (6) from the control unit
connector (5).
WASHING THE HEATING PAD
MACHINE WASHING
• The heating pad can be machine washed at 30°C with a normal cycle.
• Use the gentle spin cycle only. DO NOT run an additional spin cycle.
TUMBLE DRYING
• The heating pad can be dried in a tumble dryer on a delicate cycle,
but at the end of the drying cycle it must be air-dried to allow it to dry
completely.
17

CLEANING AND MAINTENANCE