Replacing The Wheels - Fuxtec Fx-Rmt84M Manuel

REPLACING THE WHEELS

1. Place the machine on a level surface.
2. Secure the side on which the wheel is to be changed with a sturdy block under the frame.
3. The wheels are attached with a snap ring that can be carefully removed with a screwdriver.
Note:
If you replace one or both rear wheels, make sure that
•
both wheels have the same diameter,
•
the cutting deck is aligned horizontally to avoid uneven cutting results.
•
Key and washer are firmly seated.
IMPORTANT:
Before refitting the wheel:
•
Lightly grease the axle.
•
Replace the snap ring and support washer correctly.
DISASSEMBLY, REPLACEMENT AND REASSEMBLY OF THE BLADES
WARNING:
Always wear work gloves when handling the blades.
Before dismantling:
•
Switch off the engine,
•
Disconnect the spark plug cable to prevent unintentional starting.
Manual_FX-RMT84M_FX-RMT92A_Int24_rev01
88