Adjusting The Cutting Height - Fuxtec Fx-Rm51Sa96 Mode D'emploi

Manual_FX-RM51SA96_Int24_rev3
3
3

ADJUSTING THE CUTTING HEIGHT

Raise the wheels for a low cutting height and lower the reels for a high cutting height. Adjust the cutting
size to your needs centrally using the height adjustment handle. The middle position is the most suitable
position for most lawns.
FILL OIL BEFORE STARTING THE ENGINE
Before each subsequent use, check the oil level and, if necessary, top up with SAE30 engine oil. Refer to
the table in Chapter 2 Product Specification for the filling quantity.
Your lawnmower is sold without oil.
ATTENTION:
DO NOT overfill the engine with oil. It could lead to the smoke formation in the muffler
when starting.
1) Make sure that the lawnmower is level
2) Remove the dipstick from the oil filler tube
3) Insert the dipstick and pull it out slowly to check the oil level.
IMPORTANT:
- Check the oil level before each use. Add oil if necessary. Fill up to the oil gauge on the dipstick.
- Change the oil every 50 working hours or after months. You will likely need to change the oil more
often in dusty and dirty conditions.
40