Assembly / Pre Settings - Fuxtec Fx-Rm51Sa96 Mode D'emploi

21. Assembly / Pre settings

Read this manual thoroughly and carefully before installing and using your lawnmower.
IMPORTANT:
The lawnmower is sold WITHOUT OIL OR FUEL. Your new lawnmower has been
assembled and tested at the factory.
REMOVE ANY CARDBOARD PARTS FROM THE LAWN MOWER.
Remove the device from the box and check the entire packaging thoroughly for loose parts.
A
1
2
5. Remove the lawnmower from the packaging
6. Hold folded bracket (B) by the handle and pull it upwards until it is in the correct position (A)
7. Tighten orange wing nut (1), then tighten screws + nuts (2) on both sides
8. Mount the 2 wing nuts + screws (3) and tighten them
39
Manual_FX-RM51SA96_Int24_rev3
B