Troubleshooting; Error Messages - Husqvarna PG 820 RC Manuel D'utilisation

Error messages , remote control
When the machine stops and displays a fault message and a fault code, a more complicated fault has occurred. If the
machine indicates error messages applicable to the traction motors or battery, the machine can only be operated
manually, contact service! For more information regarding fault codes, see the following table.
• Faults must be rectified before a fault message can be rest with 'OK' and work can continue
Jan 05
ERROR
Machine battery error, contact service!
Code: 0x00010201
OK
• Once the fault has been rectified and work has restarted, make sure the STOP/RUN knob on the remote control is
set to STOP (turn anticlockwise).
Fault
Message on the display
Code
0x010240 Machine battery error, contact service!
Traction overload, check that machine is not
0x010115
blocked!
0x010140 Traction motor error, contact service if error persists! Traction motor hall-sensors signals invalid value
0x01070F Temperature in machine is too high!
0x01070E Temperature in machine is too low!
0x01071F Internal error, contact service!
0x010740 Internal error, contact service!
Grinding disc driver error, contact service if error
0x010300
persists!
0x010341 Motor overload, contact service if problem persists! Too high motor current
Grinding disc driver error, contact service if error
0x010342
persists!
0x010343 Internal error, contact service!
Grinding disc driver error, contact service if error
0x010348
persists!
0x010349 Input voltage is too low!
0x01034B Grinding disc driver error, contact service!
0x01034D Temperature in machine is too low!
0x01034E Temperature in machine is too high!
0x010350 Motor overload, contact service if problem persists! Too high motor temperature
0x010356
Grinding disc driver error, contact service if error
persists!
0x010359
40 – English

TROUBLESHOOTING

12:45
OK
Cause
Battery connected incorrectly
Traction motors are overloaded
Machine temperature is high, machine is stopped
Machine temperature is low, machine is stopped
Flash/fram memory could not be read
VFD communication fault
General error
Too high DC-link voltage
Sum of motor phase current is not zero.
VFD internal error
Too low DC-link voltage
Disturbances in radio communication between the
remote control and the machine.
At least one phase without current
Too low VFD temperature
Too high VFD temperature
VFD internal error