Start/Stop Control On The Remote; Machine Stop On Remote Control - Husqvarna PG 820 RC Manuel D'utilisation

Start/stop control on the remote

STOP/RUN control used to start and stop the grinding
unit.
CAUTION! Always use STOP/RUN to stop
!
the machine after grinding.
Checking the stop/run switch on the
remote control
NOTICE! The machine is in operation during the check.
• Check that the emergency stops on the main control
panel and on the control panel are not depressed by
turning them clockwise.
• Make sure the machine stop on the remote control is
not depressed by turning it clockwise.
• Turn the switch on the control panel to '0' for remote
operation.
• Start the grinding unit by turning the STOP/RUN
switch on the remote control to RUN. The grinding unit
will then start smoothly and accelerate to the set
speed within 5 seconds.
10 – English
MACHINE´S SAFETY EQUIPMENT
• Turn the STOP/RUN switch to STOP. Check that the
grinding unit stops after approximately 2.5 seconds.

Machine stop on remote control

NOTICE! Machine stop is not activated when
maneuvering manual.
When the machine stop on the remote control is pressed,
the power to the circuits controlling the communication
with the machine is interrupted. The machine engine
stops due to the interruption of the transfer of signals to
the machine's electronic device.
Grinding unit stops after approximately 2.5 seconds.
• Do not use the machine stop to stop the machine after
grinding.
Check of machine stop
NOTICE! The machine is in operation during the check.
• Check that the emergency stops on the main control
panel and on the control panel are not depressed by
turning them clockwise.
• Make sure the machine stop on the remote control is
not depressed by turning it clockwise.
• Turn the main switch to position '1' to start the
machine.
• Turn the switch on the control panel to '0' for remote
operation.
2 1