Assembly - RIDGID RT14000 Mode D'emploi

ASSEMBLY

Front Caster/Caster Foot
Assembly
NOTE: Remove Powerhead Assembly
from Dust Drum prior to assembly of the
Caster Feet and Casters (See Attaching/
Removing Powerhead Assembly to Dust
Drum section, if needed).
1. Turn Dust Drum upside down on floor.
2. Place Caster Foot on floor, as shown.
Insert the Stem of a Caster into Socket
of Caster Foot.
3. Push on the Caster until the Caster
ball end snaps fully into the Socket and
the Caster swivel freely. Repeat for the
other Caster and Caster Foot.
4. Place Caster Foot with Caster over
post on bottom of Dust Drum and press
firmly in place, as shown.
5. Repeat for the other Caster/Caster
Foot Assembly.
Post
Dust
Drum
Rear Feet, Axle and Wheel
Assembly
1. While facing the rear of the Dust Drum,
place the Right Rear Axle Foot w/
Casters (2)
Storage over the Left Post and press
firmly in place.
2. Repeat for the Left Rear Axle Foot w/
Caster Stem
Caster Ball Storage on the Right Post. The Axle
slots in the Rear Axle Feet w/Storage
should be aligned
Front
3. Use a #10 x 3/4" (19mm) Pan Head
Caster
Screw (supplied) to secure each Rear
Foot
w/Storage
Axle Foot w/Storage to the Drum.
(2)
Left Rear
Axle Foot
w/Storage
6
Front Caster Foot
w/Storage (2)
Caster Foot
Post Hole
Right Rear
Axle Foot
w/Storage
Pan Head
Screws
Axle
Slots
Rear
Posts