Cameo ZENIT P 40 Manuel D'utilisation page 18

COLOUR TEMPERATURE (Tunable White)
Colour temperature mode enables the light to be configured with a colour temperature of cold white to warm white (CTC) and allows brightness
(Dim) to be adjusted directly on the device. Select colour temperature mode as described above under CONFIGURE STANDALONE MODE and confirm
with ENTER. Now use UP and DOWN to select the menu item you wish to edit (observe arrow) and confirm with ENTER. The display will show a
three-digit number field and you can use UP and DOWN to configure the desired value. Confirm with ENTER. Press MODE three times to return to the
main display (Tunable White Mode).
USER PRESETS (User Color)
User presets mode allows the overall brightness and a colour mixture of R, G, B and W to be saved directly in the device in five individual colour
presets. Select "User Color" as described above under CONFIGURE STANDALONE MODE and confirm with ENTER. Now use UP and DOWN to select
presets Color1 to Color5, confirm with ENTER and select the submenu item you would like to edit (observe arrow). Confirm with ENTER. The display
will show a three-digit number field and you can use UP and DOWN to configure the value between 000 and 255 as required. Confirm again with
ENTER. Once all settings have been made according to preference, press MODE four times to return to the main display (User Color Mode).
CONFIGURE SLAVE MODE
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "Slave" (observe arrow) and
confirm with ENTER. Connect the slave and master units (same model) with a DMX cable and enable one of the standalone modes on the master
unit (Auto, Colour Macro, Static, Tunable White, User Color). The slave unit will now follow the master unit. If there is no control signal, the display
characters will flash. Flashing stops as soon as a control signal is present.
DEVICE SETTINGS (Settings)
Pressing MODE will take you to the selection menu for system settings (--- Menu ---). Using UP and DOWN, select the menu item "Settings" (observe
the arrow) and confirm with ENTER.
You will then be taken to the sub-menu to set the following sub-menu items:
18