Télécharger
Partager
Imprimer la page
Toro 10101 Supplément Au Manuel
  1. Manuels
  2. Marques
  3. Toro Manuels
  4. Tondeuses à gazon
  5. 10101
  6. Supplément au manuel
Toro 10101 Supplément Au Manuel

Toro 10101 Supplément Au Manuel

Acheminement du cable
Masquer les pouces
1
2
3
4
5
6
Les langues disponibles

Les langues disponibles

Liens rapides

Télécharger ce manuel
MODEL
NO. 10101
MODEL
NO. 10120
MODEL
NO. 20645
MODEL
NO.
MODEL
NO. 20649
WARNING
POTENTIAL
HAZARD
• Excessive pulling on control cable may
cause mower
to start.
operating, blade is rotating.
WHAT
CAN
HAPPEN
• Contact with rotating mower blade could
cause serious personal injury.
HOW
TO AVOID
THE
• Do not lift mower by control cable or pull
excessively on cable.
CORRECT
ROUTING
Printed in USA
CABLE
- 6900001
& UP
- 6900001
& UP
- 6900001
& UP
20647
- 6900001
& UP
- 6900001
& UP
When
mower
is
HAZARD
F)
Figure 1
OThe Toro Company - 1995
All Rights Reserved
ROUTING
OPERATOR
ADDENDUM
IMPORTANT:
Control cable must be over,
not under, handles (Fig. 1).
1.
Lift
control
cable
2.
Slide ends of lower handle
If handle stops before screw holes are aligned in
center of shroud openings, push down on lower
handle section while pushing tubes into holes in
shroud (Fig. 2). Push tubes in until screw holes
are centered in shroud openings.
Secure
ends of lower
3.
Attach upper handles at desired height.
INCORRECT
FORM
NO. 3318-464EN
MANUAL
above
holes
in rear of shroud.
into holes in shroud.
handle
with
two
screws.
ROUTING
24202421
loading

Manuels Connexes pour Toro 10101

Sommaire des Matières pour Toro 10101

  • Page 1 • Do not lift mower by control cable or pull Secure ends of lower handle with screws. excessively on cable. Attach upper handles at desired height. INCORRECT ROUTING CORRECT ROUTING 24202421 Figure 1 OThe Toro Company - 1995 All Rights Reserved Printed in USA...
  • Page 2 Installation Instructions If handles are in lowest height position, use clip to attach cable to right side of lower handle tube (Fig. 4). 2422 Figure 2 Lower handle If handles are in highest height position, useclip to attach cable to left side of lower handle tube (Fig.
  • Page 3 Attacher le mancheron supérieur la hauteur Important: Le cåble de commandedoit passer souhaitée. au-dessus du mancheron, pas en dessous (Fig. 1). CABLE INCORRECT CABLE CORRECT 2420/2421 Figure 1 OThe Toro Company —1995 Tous droits réservés Imprimé aux USA...
  • Page 4 Instructions de montage Si le mancheron est monté dans la position la plus basse,attacherle cåble l'aide de la pince la branche de droite du mancheron inférieur (Fig. 4). 2422 Figure 2 Mancheron inférieur Si le mancheron est monté dans la position la plus haute, attacherle cåble ä...
  • Page 5 El cable de control debe estar por tornillos. encima, no por debajo, de las Instale las manijas superiores a la altura deseada. manijas (Fig. 1). RECORRIDO CORRECTO RECORRIDO INCORRECTO 2420/2421 Figura 1 OThe Toro Company —1995 Todos los derechos reservados Impresoen EE.UU.
  • Page 6 Instrucciones de instalaciön Si las manijas estån en la posici6n de minima altura, utilice la grapa parasujetar el cable en el lado derecho del tubo de la manija inferior (Fig. 4). 2422 Figura 2 Manija inferior Si las manijas estånen la posici6n de mäxima altura, utilice la grapa para sujetar eI cable en el lado izquierdo del tubo de la manija inferior (Fig.

Ce manuel est également adapté pour:

10120206452064720649