REBER GOURMET SOUS-VIDE Notice D'utilisation Et Entretien page 22

APPLIANCE SETTINGS
1) DESCRIPTION
Figure1.
The position of the display and the functions of the buttons are shown in Figure 1.
Display: Device for displaying pages.
▲: UP button.
►: Key to move the cursor to the right.
ENT: Confirmation key.
ESC: Exit button.
2) MAIN PAGES.
When the card is switched on, page C-01 is shown on the display, by pressing the ▲ key the pages of the
cooking cycles C-02, C-03, C-04, C-05, C-06, C will be selected in sequence. -07, C-08, C-09, C-10, C-11,
C-12, C-13, C-14 ... C20;
pressing the ▲ button again reads the current oven temperature and finally the oven time (see figure 2 and
3).
Figure 2 Figure 3
2.1) COOKING CYCLES PARAMETERS PAGES.
Once the desired cooking cycle has been selected with the ▲ key (see paragraph 2), its parameters can be
viewed by pressing ►.
2.1.1) Modification of cooking cycle parameters
To modify the parameters of the cooking cycles, in particular the cooking temperature (t) xxx [° C] and the
cooking time hh.mm, just press ENT while the parameter to be modified is displayed and this will start to
flash. To change the value press ▲ then ENT instead to change parameter press ►; while to return to the
main menu press ESC.
The modification of the parameters is active for the cooking cycles from C-1 to C-20.
3) START OF THE COOKING CYCLE.
Once the cooking cycle (C1... .C20) has been selected, press the ENT key to activate it.
(Only from APP it is possible to set a cycle start delay on all available programs)
3.1) PAGES WITH COOKING CYCLE IN PROGRESS.
22
V. 01.2020