Meec tools 010582 Traduction Des Instructions D'origine page 74

EN
TROUBLESHOOTING
Problem
The chain saw will not start.
The chain does not stop within
2 seconds after releasing the power
switch.
The chain and/or bar get hot and
produce smoke.
The saw does not saw well.
The chain oil is not consumed.
74
Possible cause
The lock button on the power
switch has not been pressed in.
The kickback guard has released
(handle in front position).
The fuse has tripped.
The residual current device Has
tripped.
The power cord is not properly
plugged in.
The chain is too slack.
The oil tank is empty.
The oil hole in the bar is blocked.
The chain is too tight.
The sprocket on the bar needs
lubricating.
The chain is fitted backwards.
The chain is worn.
Impurities in the oil tank.
The ventilation hole in oil filler cap
is clogged.
Fouling in the bar.
The oil outlet is blocked.
Action
Press the lock button on the power
switch.
Reset the kickback guard.
Replace the fuse.
Check and reset the residual
current device.
Check the power cord and power
point.
Check and tension the chain.
Top up with oil.
Clear the oil hole and chain slot.
Check and slacken the chain.
Lubricate the sprocket on the bar.
Check the chain and fit in the
correct direction of rotation.
File or replace the chain.
Empty the oil tank and fill with
new oil.
Clear the ventilation hole.
Clear and clean the bar.
Clear.