Beta C48M Mode D'emploi page 11

EN
INSTRUCTIONS FOR USE
- In case the cart is operated in small spaces
To activate the manual mode, press the motor brake release button (7); keep it pressed to freely move the cart, without using the
throttle handle.
This mode can be used only with the key turned to (I), and only to move/adjust the position of the cart through small movements.
Releasing this button will cause the electric motor to be reconnected and switching to the motorized mode.
- In case the battery runs down completely during use
To activate manual handling, turn the key to (O) and pull up the lever between the driving wheels (11) to release the motor brake
( ↑Manual operation), thereby disconnecting the brake motor permanently and making it possible to complete the operations
without the electric motor, operating the cart like any non-motorized cart.
After the batteries have been recharged, pull the motor lock lever (11, ↓Power operation) downwards, to reconnect the motor
and switch to the motorized mode.
NB: If the cart is operated with the motor brake in the released mode and the key turned to (I), handling with the butterfly handle
would not be possible.
The indicator on the control board will flash fast intermittently, and the buzzer will ring.
To switch to the motorized mode, pull down the motor lock/release lever (11).
MAINTENANCE
Repair and calibration jobs must be carried out by trained personnel only. For such jobs, you can contact
Beta Utensili S.P.A.'s repair centre.
DISPOSAL
The cart, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This cart is manufactured and tested in accordance with current EU regulations. It is covered by a 12-month warranty for
professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at
our discretion.
The tool must be delivered to the Purchasing Centre complete with the relevant documentation (proof of purchase).
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain
unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls.
In addition, this warranty will no longer be valid if any changes are made, or if the tool is forced or sent to the customer service
in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential

EU DECLARATION OF CONFORMITY
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of the
following Directives and amendments thereto:
• Machinery directive 2006/42/CE
The Technical Brochure is available at:
BETA UTENSILI S.p.A.
Via A. Volta 18,
20845 Sovico (MB)
ITALY
11