Wilo Stratos 1.25x3-20 Notice De Montage Et De Mise En Service page 30

English
If no setting is made in the subsequent menu within 30 s, then the display will once
again show the basic setting
Error display
LC display
8.2.4 Priorities on the operation of the pump, IR module
The display of errors (menu 10) incl. error acknowledgment has the highest
priority. This means that errors precedence on the pump's display and that they
must be acknowledged and removed.
If settings are made on the control module or from the IR module and not
confirmed by pressing the button, the setting will return to the previous
position 30 seconds after the last entry.
• Pump l IR without lockout function: The last command, whether from the IR
monitor or control module, is stored by the pump.
• Pump l IR with lockout function: When the "Key function on" command is
received, the control module's current settings remain in place. The display
shows
26
.
Setting
In the event of an error the current error is
displayed by E = Error, the code no. and by the
flashing of the error source motor, control module
or mains connection.
For code numbers and their meaning see
chapter 10
. The pump is now blocked and cannot be operated.
Subject to technical alterations!
The display "m ft" appears, for which the
unit that is set will be flashing. (Works
setting [ft]).
Rotating the control button will change
the setting to [m]. The new setting will
begin flashing.
The new setting is saved by briefly press-
ing the button.
Display returns to basic setting .
WILO SE 02/2011