Wilo Stratos 1.25x3-20 Notice De Montage Et De Mise En Service page 24

English
LC display
If no setting is made in the subsequent menus for 30s,
the basic setting
20
Setting
Current (basic) setting (factory default):
auto
e.g. H 18.0 ft
re-appears in the display.
Position setting of display vertical / horizontal
The set position of the display is shown by the
flashing "ON".
Subject to technical alterations!
• automatic night setback
enabled,
Pump runs in control mode
• missing = Single-head pump
• present differential pressure
setpoint H
S
time ½ H
max
s
depending on pump type)
• Control mode 'p-v
The differential pressure set point can
be altered by turning the control button.
The new differential pressure set point
flashes.
The new setting is stored by pressing
the button briefly.
If no button is pressed, the previously
set flashing differential pressure set
point returns to the previous value after
30 seconds.
Press control button for > 1 second.
The next menu point
By turning the control button the other
position can be selected.
Setting stored.
= 18.0 ft at same
(factory setting
appears.
WILO SE 02/2011