Temperature And Moisture - IKEA WRF560SEHZ Instructions D'installation Et D'utilisation

PROBLEM
Temperature is too warm
Temperature is too cold in the
refrigerator/crisper
Temperature is too cold in the
pantry drawers
There is interior moisture
buildup
NOTE: Some moisture buildup is
normal.
There is frost/ice buildup in the
freezer compartment
20

Temperature and Moisture

POSSIBLE CAUSES
The refrigerator has just been
installed
Cooling is turned off
The controls are not set correctly
for the surrounding conditions
The door(s) are opened often or
not closed completely
A large load of food was recently
added
The refrigerator air vent(s) are
blocked
The controls are not set correctly
for the surrounding conditions
The ice storage bin is not in the
correct position
The control is not set correctly for
the items stored in drawer
The room is humid
The door(s) are opened often or
not closed completely
The door is blocked open
A bin or shelf is in the way
Storing liquid in open containers
The doors are opened often or left
open
Poor door seal
Temperature controls are not set
correctly
SOLUTIONS
Allow 24 hours following installation for the refrigerator to
cool completely.
Turn on cooling. See "Using the Controls."
Adjust the controls a setting colder. Check the
temperature in 24 hours. See "Using the Controls."
Allows warm air to enter refrigerator. Minimize door
openings and keep doors fully closed.
Allow several hours for refrigerator to return to normal
temperature.
If the air vent located in the top, left, rear corner of the
refrigerator compartment is blocked by items placed
directly in front of it, the refrigerator will get too cold.
Move items away from the air vent.
Adjust the controls a setting warmer. Check the
temperature in 24 hours. See "Using the Controls."
See "Ice Maker."
Adjust the control setting. See "Refrigerator Features."
A humid environment contributes to moisture buildup.
Allows humid air to enter the refrigerator. Minimize door
openings and close doors completely.
Move food packages away from door.
Push bin or shelf back into the correct position.
This adds humidity to the refrigerator interior. Keep all
containers tightly covered.
Minimize door openings and keep doors fully closed.
Ensure door seals are making full contact with the
refrigerator cabinet to allow for an adequate seal.
See "Using the Controls" for recommended temperature
settings.