Adjustment; Temperature Control - IKEA WRF560SEHZ Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE: Areas such as a garage or porch, may experience
warmer or colder temperatures and higher humidity than inside
the home. You may need to adjust the temperature away
from the recommended set points to accommodate for these
conditions.
If the temperature is too warm or too cold in the refrigerator
or freezer, before adjusting the controls, first check the air
vents located in the refrigerator and freezer compartments to
be sure they are not blocked by food items.
Control Panel
The control panel is located inside the refrigerator compartment.
This control operates both the refrigerator and freezer
compartments.
The control panel will display the Home Screen, as shown, when
either refrigerator door is opened.

Temperature Control

For your convenience, the temperature control is preset at the
factory. When you first install your refrigerator, make sure the
control is still set to the recommended setting as shown.
Recommended Setting (3 lit boxes)
Adjusting the Temperature:
If you need to adjust the temperature in either the refrigerator
or freezer compartment, use the settings listed in the following
chart as a guide.
Press either the FREEZER TEMP or FRIDGE TEMP button to
select the desired temperature setting from (1 box [least cold]
to 5 boxes [coldest]).
NOTE: Except when starting the refrigerator, do not adjust
the control more than one setting at a time. Wait 24 hours
between adjustments for the temperature to stabilize.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too
little ice
REFRIGERATOR too cold
FREEZER too cold
Cooling Off/On
Your refrigerator and freezer will not cool and water will not
dispense when cooling is turned off.
To turn cooling off, press and hold both the MAX COOL and
MOISTURE CONTROL buttons, at the same time, for
3 seconds. When cooling is off, "Cooling Off" will appear on
the display screen.
To turn cooling back on, press and hold both the MAX COOL
and MOISTURE CONTROL buttons, at the same time, for
3 seconds. When cooling is on, "Cooling Off" will disappear
and the previously selected settings will appear on the
display screen.
Additional Features:
Max Cool
The Max Cool feature assists during times of high refrigerator
use,full grocery loads or temporarily warm room temperatures.
Press MAX COOL to set the freezer and refrigerator to the
coldest temperature settings. Press MAX COOL again to
return to the selected temperature set point.
NOTES:
The Max Cool icon will be illuminated while the refrigerator is
in Max Cool mode.The displayed compartment temperature
settings will not change.
The Max Cool feature will turn off automatically after 24
hours.
Moisture Control
The moisture control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments
or when you notice moisture on the door hinge seal. The
refrigerator uses more energy when Moisture Control is on.
To turn on the Moisture Control feature, press and hold
MOISTURE CONTROL for 3 seconds.
To turn off the Moisture Control feature, press and hold
MOISTURE CONTROL for 3 seconds.

ADJUSTMENT:

FRIDGE TEMP one setting
(box) more
FREEZER TEMP one setting
(box) more
FRIDGE TEMP one setting
(box) less
FREEZER TEMP one setting
(box) less
13

Publicité

Table des Matières
loading

Table des Matières