IKEA WRF560SEHZ Instructions D'installation Et D'utilisation page 22

Water is leaking or dripping
from the dispenser system
NOTE: A few drops of water after
dispensing is normal.
Water continues to drip from
the dispenser beyond the first
few drops.
Water is leaking from the back
of the refrigerator
Water from the dispenser is
warm
NOTE: Water from the dispenser
is only chilled to 50°F (10°C).
22
There is a kink in the
water source line
The refrigerator has just
been installed
The water pressure to the
house is not at or above
30 psi (207 kPa)
A reverse osmosis
water filtration system is
connected to your cold
water supply
A water filter is installed
on the refrigerator
The refrigerator door is
not closed completely (on
some models)
The refrigerator doors
were recently removed
The glass was not held
under the dispenser long
enough
The refrigerator has just
been installed
The water filter was
recently changed
The water line
connections were not
fully tightened
Recently removed
the doors and did not
fully tighten water line
connection
The refrigerator has just
been installed
A large amount of water
was recently dispensed
Water has not been
recently dispensed
The refrigerator is not
connected to a cold
water pipe
A kink in the water line can reduce water flow from the water
dispenser and result in hollow or irregular shaped ice. Straighten
the water source line.
Flush and fill the water system. See "Water Dispenser."
The water pressure to the house determines the flow from the
dispenser. See "Water Supply Requirements."
A reverse osmosis water filtration system can decrease water
pressure. See "Water Supply Requirements."
Remove filter and operate dispenser. If water flow increases, the
water filter may be clogged or incorrectly installed. Replace filter
or reinstall it correctly.
Close the door firmly. If it does not close completely, see "The
door(s) or drawer will not close completely."
Make sure the water dispenser wire/tube assembly has been
properly reconnected at the top of the refrigerator door. See
"Remove and Replace Refrigerator Doors and Drawer Front."
Hold the glass under the dispenser 2 to 3 seconds after releasing
the dispenser lever.
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system. See
"Water Dispenser."
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system. See
"Water Dispenser."
See "Connect the Water Supply."
See "Remove and Replace Refrigerator Doors and Drawer Front."
Allow 24 hours after installation for the water supply to cool
completely.
Allow 3 hours for the water supply to cool completely.
The first glass of water may not be cool. Discard the first glass of
water dispensed.
Make sure the refrigerator is connected to a cold water pipe. See
"Water Supply Requirements."