Unold 48850 Notice D'utilisation page 29

10. Let the ice cream maker run until the ice cream has the desired consist-
ency. Depending on the ingredients this takes 15 to 25 minutes. Check the
freezing process from time to time. However we recommend that you not
switch the appliance on or off too frequently, because through so doing the
ice cream can firmly freeze onto the edge of the container and it is possible
that the mixer will no longer work correctly.
11. Always switch the appliance off when the mixer is at a standstill to prevent
the motor from overheating. Then allow the appliance to cool down slightly
and switch the appliance on again.
12. Switch off the appliance via the ON/OFF switch.
13. Take off the motor and the lid by turning the unlock switch to  and lifting
the lid with the motor upward and off.
14. Pull the mixers out of the cooling containers.
15. Take the cooling containers off of the appliance base.
16. It is best to remove the ice cream with a plastic or wooden spatula, so as not
to scratch the containers.
17. Ice cream should have a soft consistency. However, if you prefer harder ice
cream, then additionally place the container in the freezer compartment/
freezer.
18. However do not keep the ice cream in the container in the freezer compart-
ment for longer than 30 minutes. If you do not want to eat the ice cream
immediately, then put it in a freezer box and then place this freezer box in
the freezer compartment. In this regard, due to the contraction of ice crys-
tals the ice cream can form water streaks because the optimal ice cream
temperature is approx. −10°C, but the temperature in the freezing devices
is usually lower.
19. If the ice cream has not reached the desired consistency, and you want to
again commence preparation, you must first take the lid off of the motor.
Then re-assemble all parts, as described in the section, „Assembly". This
ensures that the axles of the mixers are inserted correctly.
20. Caution: However do not switch off the appliance while it is making ice
cream. This would cause the ice cream mixture to freeze to the edge of the
cooling container. If the motor should overheat when ice cream is being
prepared, the motor switches off. In this case, place the ON/OFF switch on
„OFF", unplug the power plug and allow the appliance to cool. If you want
to continue preparing ice cream, it may be necessary to use new ice cream
ingredients. In this case the ice cream should be removed from the cooling
container with a plastic spatula, not through the discharge opening!
Copyright UNOLD AG | www.unold.de
29