Ryobi PBV-30 Manuel D'utilisation page 19

GB
F D
INSTRUCTIONS
When unpacking the blower:
Carefully remove the blower and accessories from
■
the box.
Make sure that all items listed in the packing list
■
are included.
Inspect the blower carefully to make sure no
■
breakage or damage occurred during shipping.
Do not discard the packing material until you have
■
carefully inspected and satisfactorily operated
the blower.
WARNING
If any parts are missing do not operate the
blower until the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
Note: Read and remove all hang tags and store with your
operator's manual.
ASSEMBLY
WARNING
Stop the engine and disconnect the spark plug
wire before installing parts, making adjustments,
cleaning, or when not in use. Failure to do so
could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
(See Figure 2.)
1. Screw the nozzle (3) onto the upper blower tube (4)
and tighten securely. Check tightness after initial run
and retighten if needed.
2. Place clamp around the neck of the blower housing
outlet. Do not tighten the wing nut yet.
3. Align the locking tab on upper blower tube with the slot
in the blower housing outlet; push the tube into the
housing. Twist to lock into place.
4. Rotate the tube so the nozzle is pointing upward as
shown. Tighten the wing nut securely.
5. To remove the tubes, loosen the wing nut on the
clamp. Rotate the tubes to unlock them remove from
the blower housing outlet.
INSTALLING THE VACUUM BAG
(See Figures 3 and 4.)
1. Remove the nozzle and upper blower tube from
the blower.
E I P NL S DK N FIN
English
2. Unzip the vacuum bag (16) and place the adaptor (15)
inside as shown.
3. Align the locking tab on the bag adapter with the slot in
the blower housing outlet; push the bag adaptor into
the housing. Twist to lock into place.
4. Tighten the wing nut securely.
5. Rotate the vacuum bag until the shoulder strap is
upright.
6. Make sure the vacuum bag is zipped and closed
before starting the unit.
WARNING
Stop the engine and disconnect the spark plug
wire before installing parts, making adjustments,
cleaning, or when not in use. Failure to do so
could result in possible serious personal injury.
INSTALLING THE VACUUM TUBES
(See Figures 5 and 6.)
To install the vacuum tubes:
1. Screw the upper and lower vacuum tubes together and
tighten securely.
2. Loosen the door knob (9) on the inlet cover door (10)
and open. Place the notch in the support arm (23) of
the upper vacuum tube under the hinge (21) of the
inlet cover door.
3. Push the upper vacuum tube into the blower housing.
4. Align the upper vacuum tube knob (22) with the hole in
the housing and tighten securely.
To remove the vacuum tubes:
1. Loosen the upper vacuum tube knob.
2. Remove the vacuum tubes from the blower housing.
3. Close the inlet cover door and tighten the door knob
securely.
OPERATION
WARNING
Gasoline is extremely flammable and explosive.
A fire or explosion from gasoline will burn you
and others.
MIXING THE FUEL
This product is powered by a 2-stroke engine and
requires pre-mixing gasoline and 2-stroke oil.
The mixture should be at a 50:1 ratio, using Synthetic
2-stroke oil. If Synthetic 2-stroke oil is not available,
use a high quality 2-stroke engine oil, mixed at a 50:1 ratio.
See chart later in this section.
14
GR H CZ RUS RO PL