Pulse Output (If Available); Launching Quick Start - Gorgy Timing RADIO TIMING CP09 Mode D'emploi

3.7. PULSE OUTPUT (IF AVAILABLE)

If the RTCP09 has a pulse output, you can use this screen to carry out simple clock syn-
chronization tasks.
By entering a time, which is the time displayed on the clocks to be synchronized, the
RTCP09 will automatically send the correct number of pulses to synchronize the clock
network once again.
► "1 MINUTE": In this operating mode,
one pulse will be sent every minute (60
seconds).
► "1/2 MINUTE": In this operating mode,
one pulse will be sent every half-minute
(30 seconds).
☛
The
► Example 1: If it is 12:00 hrs and the clocks stopped at 11:30 hrs, enter "11:30" in
the corresponding fields, and confirm by clicking "OK". The
pulses to the chain such that the clocks make up for their delay of 30 minutes in a
few seconds.
Example 2: If the clocks stopped at 12:05 hrs, when the time is 12:00 hrs, the
►
RTCP09 will automatically suspend the pulses until the time becomes 12:05 hrs.

3.8. LAUNCHING QUICK START

90
RTCP09 cannot suspend pulses for more than two hours.
☛
See Section 4 QUICK START
RTCP09 will then send
MDE-RTCP09-3060V2.2