Publicité
WARNING
Electrocution hazard – risk of serious personal injury and/or damage to equipment.
Before performing any maintenance tasks, make sure all power to the device has been disconnected and wait
approximately two minutes for any remaining energy to dissipate.
Observe the five rules of electrical safety:
•
Disconnect system
•
Secure against reconnection
•
Verify the system is de-energized
•
Ground and short circuit the system
•
Cover or block off neighboring live parts
WARNING
Electrocution hazard – risk of serious personal injury or death
Make sure all power sources are de-energized before servicing the power supply terminals.
WARNING
Electrocution hazard – risk of death, serious personal injury, and/or damage to the device
Prevent contact with exposed wire leads while the device is energized. Make sure the supplied safety cover is
always installed when high voltage screw-type terminal blocks are used.
WARNING
Electrocution hazard – risk of death, serious personal injury, and/or damage to
the device
Make sure the supplied safety cover is always installed before the device is powered.
WARNING
Electrocution hazard – risk of serious personal injury or death
Make sure power to the device is turned off before servicing the power supply terminal.
Applies to RST2428P only.
WARNING
Do not use any parts that show evidence of damage
If you use damaged parts, there is no guarantee the device will function according to the specification.
If you use damaged parts, this can lead to the following problems:
•
Injury to persons
•
Loss of approvals
•
Violation of the EMC regulations
•
Damage to the device and other components
Use only undamaged parts.
40
RUGGEDCOM RST2000 series Industrial Ethernet switches
C79000-G8999-1656-01
Publicité
