Publicité
Polaris
FREEDOM
SC Cordless Robotic Cleaner | Owner's Manual
®
™
Figure 6. Slide and Release Right to Start
3. Cleaner does not begin moving until it senses water.
A blinking blue LED light means it is ready to clean.
3.5
Submerge the Cleaner
1. At the center point, submerge the cleaner in the pool
and hold in the vertical position to release any air
trapped inside.
1
Figure 7. Submerge the Cleaner Vertically
2. Wait for bubbles to stop completely, then let the
cleaner sink to the bottom of the pool.
2
Figure 8. Cleaner Sinking to the Bottom of the Pool
3. Cleaning cycle will start as soon as the cleaner detects
the pool floor or 40 seconds after detecting the water.
WARNING
Do not enter pool while the robotic cleaner is in water.
3.6
Removal
During the last 10 minutes of the cycle, the cleaner will
climb to different walls and wait at the waterline. Remove
using the handle. Water will expel to make it lighter
(Not available in Floor Only mode). If the cleaner is not
removed at the waterline, it will return to the floor at the
end of the cycle.
NOTE: If connected to the iAquaLink
sent to your mobile device during this time to alert you to remove
the cleaner while waiting.
3.6.1 Tap & Lift
Retrieval
™
1. After the cycle is complete, attach the hook to a
standard pool cleaning pole (not included).
Figure 9. Removel Hook
2. Tap cleaner lid once (x1). The cleaner will drive to the
wall it is facing and climb to waterline.
NOTE: Delay may occur between tap and cleaner movement.
Figure 10. Tap & Lift
3. Remove using the handle. Water will expel to make
it lighter.
ENGLISH
app, push notifications will be
®
Page 9
Publicité
