Publicité
Polaris
FREEDOM
SC Cordless Robotic Cleaner | Owner's Manual
®
™
7.2
Cleaner Error Codes
On/
Blinking Red
Off
Display
Error
in the
#
iAquaLink
®
App
Communication
10
error
14
Motor block error
Traction motor
2 & 3
left/right
Drive motor
5 & 6
consumption
left/right
7
Cleaner floating
Cleaner out of the
8
water
1 & 4
Pump motor
Firmware Update
12
Error
Solutions
• The cleaner board is under power but does not respond.
• Contact your service center for a diagnostic review or
contact Technical Support at 1.800.822.7933.
• Check that debris is not preventing the brush or tracks from
moving freely.
• Rotate each wheel by a quarter of a turn in the same
direction until it rotates smoothly. Repeat turning wheels in
the opposite direction until rotation is smooth.
• Contact your service center for a diagnostic review or
contact Technical Support at 1.800.822.7933.
• Thoroughly clean the filter canister.
• Restart the cycle, then submerge cleaner in the water and
shake to release air bubbles.
• Contact your service center for a diagnostic review or
contact Technical Support at 1.800.822.7933.
• Turn off the cleaner using the slider by sliding to the left and
hold for 20 seconds. No LEDs will be illuminated.
• Check for small debris or hair in the fan impeller.
• Thoroughly clean the filter canister.
• Contact your service center for a diagnostic review or
contact Technical Support at 1.800.822.7933.
• Close the iAquaLink
app.
®
• Check that the cleaner is connected to the Wi-Fi network
(the LED is solid blue).
• If the indicator is not steady, open the iAquaLink app, select
the cleaner and click on "Update".
ENGLISH
Page 17
Publicité
