Publicité
ENGLISH
WARNING
Failure to comply with the following warnings can result in
permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK AND FIRE
• Only connect the cleaner to a receptacle protected by a
ground fault circuit interrupter (GFCI). Contact a certified
electrician if you cannot verify that the receptacle is
protected by a GFCI.
• Do not use an extension cord to connect the cleaner.
• Do not allow anyone to swim while the cleaner is in the
pool.
• Follow all charging instructions and do not charge
cleaner outside of the temperature range specified in
the instructions. Charging improperly or at temperatures
outside of the specified range may damage the battery
and increase the risk of fire.
3.2
Information/Status LEDs
Battery Status
Solid Green
Blinking Green
Solid Orange
Blinking
Orange
Blinking Red
Wi-Fi Connection
Status
Blinking Blue
Solid Blue
Operating Status
Blinking Blue
Blinking Red
Floor, walls,
and waterline
(2 hours)
Floor Only
(1 h 30 min)
The Cleaner goes into deep sleep after 8 days of inactivity
to protect the battery. When all indicators are off, the
cleaner is in sleep mode. Re-set the cleaner to wake it up.
If this does not work, see troubleshooting.
Page 8
Fully charged.
Ready to run a full cycle
(2 hours).
Not fully charged. May not run a
complete floor & wall cycle.
Very low battery level. Charge
required. Cannot run cleaner.
Charging error. Cleaner is
too hot.
Pairing.
Connected to Wi-Fi.
Out of Water: Ready to
submerge, start cleaning.
In Water: End of cycle. Waiting
for removal from pool.
Error. See app or troubleshooting.
Selected Cleaning Mode.
Polaris
FREEDOM
SC Cordless Robotic Cleaner | Owner's Manual
®
™
3.3
Charger Status
Solid Green
Solid Red
Figure 4. Charger Status LED
3.4
Start Cleaner
1. Select Cleaning Mode using the slider by sliding and
releasing to the left or by using the App.
Cleaning Mode
Floor/Wall
Floor
Figure 5. Slide and Release Left to Select Mode
NOTE: Choose Floor Only mode to clean with Pool Cover on.
2. Start the cleaner using the slider by sliding and
releasing to the right or use the App.
Charger is receiving power
Charging is in progress
Select
Runtime
Product or App
2 hrs
Product or App
1.5 hrs
Publicité
