Publicité
Polaris
FREEDOM
SC Cordless Robotic Cleaner | Owner's Manual
®
™
How to connect:
You must connect to the home router (network) with your smart device which will communicate with the cleaner. (See
Configure the System .)
It is recommended to locate the cleaner as close to the home router as practical. Do not use an extension cord.
Common iAquaLink
Troubleshooting
®
Remember, if you get a new Wi-Fi Router, reset the defaults of your current Wi-Fi Router or simply change your Wi-Fi
network password, you will have to re-establish the connection between your cleaner and the router. (See: Configure the
System .)
User Issue
Wi-Fi light is off.
Wi-Fi light is flashing.
Wi-Fi light is on but buttons and functions
are disabled.
IMPORTANT
Possible Cause
Bright sunlight
Charger is unplugged.
Power outage.
Lost internet connection.
Router is off.
Router password was changed.
Lost internet connection
Weak Wi-Fi signal.
Connectivity issue with local Wi-Fi or connection
to the server.
Firmware update in progress.
Suggested Solution
Shield the lights to block sunlight and re-check if
the lights are lit.
Plug the charger into a GFCI outlet (see Connect to
a Power Source ).
Verify that the breaker is on and electricity is being
supplied to the outlet.
Check internet connection - network may be down.
Turn router on.
Delete robot and reconnect with new router
password.
Check internet connection - network may be down.
• Check for adequate Wi-Fi signal strength.
• With a Windows laptop, go to Network
Connections in the Control Panel. Check
Signal Strength meter under Wireless Network
Connection icon while standing near the cleaner.
• With a smart device, search for, download, and
use an app that can check signal strength while
standing near the cleaner. If Wi-Fi signal is weak,
consider installing a Wi-Fi extender.
Contact your local internet service provider.
• Unplug your cleaner and wait 10 seconds. Plug
in the box again and see if lights illuminate.
• Check Internet connection - network may
be down.
"PROG" is displayed in the app during an
over-the-air firmware update. Simply wait for button
functions to resume after update completes. Do not
unplug from power during an update.
ENGLISH
Page 19
Publicité
