Publicité
MAINTENANCE
- 10 days after the installation of your fan, check the screws of the blades, and
all the fixings of your fan.
- If necessary, screw the screws again. In case you notice that the fan attachment
has gotten loose, re install it.
- Clean your fan with a dry, non-abrasive cloth to prevent damaging the paint
- You should not oil the fan; the latter is equipped with a self- lubricating motor,
that uses a high specific viscosity oil.
- In case of any doubt, please contact your distributor
For these operations, make sure the power supply is off.
TROUBLESHOOTING
The fan does not
start
The fan is noisy
The fan vibrates
Customer service:
aftersales@klassfan.com
contact@klassfan.com
Tel : +34 960 082 885
1. A cable is disconnected.
2. A circuit breaker is
disconnected.
3. The switch of the line is
in closed position.
4. The batteries are empty.
5. The remote control is
not paired.
1. A screw is lost.
2. Metal parts rub together.
3. The canopy touches the
ceiling.
1. The installation of the
blades is not correctly
performed.
39
1. Check the electrical
connections
2. Check your circuit breaker.
3. Activate your switch.
4. Change the batteries.
5. Re-pair your remote.
1. Check and fix the screws.
2. Carefully disassemble the
fan.
3. Check the canopy.
1. Review the steps of
balancing your fan.
Publicité
