Change Code - Me Bell-510 Rx Mode D'emploi

ENGLISH
BELL-219 TX
MELODY SELECTION
If the side selection button (8) for the ring tones is pressed, the melody of the
receiver changes, the last melody selected is automatically saved. There are
8 melodies to choose from.
ACOUSTIC CALL DIFFERENTIATION
When operating the BELL-219 TX and another m-e radio transmitter at the same
time, both units can be set to different melodies. This allows you to distinguish
acoustically which radio transmitter has triggered.

CHANGE CODE

If the receiver (radio chime or radio bell) sounds without a sound being detected
by the BELL-219 TX, this may be due to a device in your environment that is
operated with the same transmission code. In this case, change the transmission
code. To do this, remove the batteries from the transmitter for 10 seconds, this
will delete the transmission code. If you insert the batteries again, the radio
transmitter automatically searches for a new transmission code. Then reset the
GB
receiver (restore factory settings) and activate the learning mode (see receiver
instructions). Then trigger the BELL-219 TX so that the receiver learns the new
transmission code.
BATTERY
The sound-active radio transmitter is powered by 2 AA 1.5Volt batteries (not sup-
plied). To insert or change the batteries, remove the battery compartment cover
by sliding it slightly in the direction of the arrow. Then remove the battery com-
partment cover and insert two 1.5 volt AA batteries into the battery compart-
ment with the correct polarity. Place the battery compartment cover back over
the batteries and push it closed until it clicks into place.
Attention
When inserting the batteries, please observe the polarity as shown in the illus-
tration. Rechargeable batteries must not be used as they have a lower voltage
20