Me BELL-510 RX Mode D'emploi page 199

ENGLISH
BELL-219 TX
LEGEND
1 = BELL-219 TX
2 = Battery control LED
3 = Sensitivity value viewing window
4 = Sensitivity dial
5 = Transmit control LED
6 = Sensor socket
7 = Sensor plug
8 = Ring tone selection button
9 = Sensor
10 = Hanger
11 = Battery compartment
12 = Battery compartment cover
COMMISSIONING
To put the sound-active radio transmitter into operation for the first time, open
the battery compartment and insert the batteries into the battery compartment
GB
with the correct polarity. Close the battery compartment again. The radio trans-
mitter now automatically sets a transmission code and can be tuned in to a suit-
able receiver. Connect the sensor to the BELL-219 TX by inserting the sensor plug
(7) into the sensor socket (6).
Put the receiver into learning mode. During the first start-up, it is already in
learning mode as soon as the batteries are inserted in the receiver. If another
transmitter has already been tuned in, refer to the instructions for the receiver to
find out how to tune in other transmitters.
If the receiver is in learning mode, briefly press the selection button for the ring
tone once or activate the BELL-219 TX by making a noise (e.g. knocking on the
sensor). This causes the radio transmitter to transmit the set transmission code
to the receiver and the receiver plays a melody.
The radio transmitter is now ready for operation and you can continue with the
installation.
Finally, adjust the sensitivity of the sensor to your conditions as described in the
section "Adjusting the sensitivity".
17