Setting The Sensitivity - Me Bell-510 Rx Mode D'emploi

ENGLISH
BELL-219 TX

SETTING THE SENSITIVITY

On the side is the adjusting wheel (4) with which the sensitivity of the sensor can
be continuously adjusted. The set sensitivity can be read in the viewing window
(3). 0 corresponds to the lowest sensitivity and 6 corresponds to the highest
sensitivity. If the BELL-219 TX also triggers in case of quiet or disturbing noises,
turn the setting wheel to a smaller number. If the BELL-219 TX does not trigger
at all, turn the dial to a higher number. The sensitivity can be adjusted continu-
ously.
Procedure for initial start-up
Turn the setting wheel to the lowest sensitivity and then trigger your bell. If the
BELL-219 TX already reacts, the sensitivity is set correctly. If the BELL-219 TX
does not trigger, increase the sensitivity slightly and then test again. Repeat the
procedure until the BELL-219 TX reliably detects your bell and no longer reacts to
interfering noises.
Note
If you turn the setting wheel, the transmitter may trigger even without noise.
Wait briefly until the transmitter no longer sends a signal (transmission control
GB
LED off) and the paired radio receiver has finished its melody and light signals.
Then test the sensitivity again. If the BELL-219 TX does not trigger, increase the
sensitivity further.
Note
Set the volume of your bell (if possible) to maximum volume before adjusting
the sensitivity of the BELL 215 TX transmitter. In this way, the ring tone can be
recognised better and the sensitivity of the sensor can be set as low as possible.
False triggers due to extraneous noise can thus be further reduced.
19