Korg KAOSS PAD KP2 Manuel D'utilisation page 10

About the MIDI implementation chart
The owner's manual of each MIDI device in-
cludes a "MIDI implementation chart." This
chart lets you check the types of MIDI mes-
sage that can be transmitted or received.
When you use two (or more) MIDI devices to-
gether, compare their MIDI implementation
charts to see which types of MIDI message
they are able to transmit and receive between
themselves.
* Details on the MIDI functionality are provided
in the separate MIDI implementation. To obtain
the MIDI implementation, please contact Korg
distributor.
MIDI Edit mode
Hold down the Tap/BPM key and press the
Rec/Stop key. After approximately one sec-
ond, you will enter MIDI Edit mode, and
the MIDI channel will be displayed blinking
in the Program/BPM display.
Setting the MIDI channel
In MIDI Edit mode, the Program/BPM dis-
play will show the MIDI channel. At this
time you can use the Program/BPM knob to
change the MIDI channel.
MIDI message transmission/
reception settings
Transmission and reception of each type of
MIDI message can be turned on/off by
pressing one of the keys listed below. Trans-
mission and reception are enabled when the
corresponding LED is lit. Transmission and
reception are disabled when the LED is
dark.( p.9: Messages that can be transmitted
and received)
Some parameters can only be transmitted,
and others can only be received.
Changing the control number
By holding down one of the Program
Memory 3–8 keys and turning the Pro-
gram/BPM knob, you can change the con-
trol number setting. Although it is possible
to select a control number that is already in
use, it is not possible to simultaneously turn
on transmission and reception for MIDI
8
messages of the same control number.
The MIDI messages transmitted and received
by the KP2 can be changed in the range of CC#1–
CC#31 and CC#64–CC#95.
To store the settings you modified
In MIDI Edit mode, press and hold the Rec/
Stop key for one second or longer, and the
MIDI settings you modified will be stored.
If you turn off the power without storing
the modified settings, they will revert to
their previous state.
To exit MIDI Edit mode
You will return to the normal state if you
touch the touch pad or leave the KP2 for ten
seconds without performing any operation.
Saving your settings
You can save the contents of program
memory and the control number settings of
MIDI edit mode by transmitting them as ex-
clusive messages, and saving them on an
external MIDI device.
For details on the exclusive messages that
the KP2 can transmit and receive, refer to
the separate MIDI implementation.