Worx WG260E Mode D'emploi page 9

Do not burn
Waste electrical products must not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
2.COMPONENT LIST
1. BATTERY PACK *
2. REAR HANDLE
3. FRONT HANDLE
4. SAFETY GUARD
5. FRONT SWITCH LEVER (ALL AROUND
SWITCH FUNCTION)
6. REAR SWITCH LEVER
7. BATTERY PACK RELEASE BUTTON *
8. BLADE
9. BLADE SHEATH
* Not all the accessories illustrated or described are
included in standard delivery.
3.TECHNICAL DATA
Type WG260E WG260E.X (230-269- designation
of machinery, representative of cordless hedge
trimmer)
Voltage
No load speed
Max.cutting length
Max.cutting
diameter
Machine weight
(bare tool)
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal volt-
age is 18 volts.
*** X=1-999, A-Z, M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models.
Cordless Hedge Trimmer
WG260E WG260E.X ***
20V Max** Lithium
2600/min
61cm
20mm
2.3kg
SUGGESTED BATTERIES
AND CHARGERS
Category
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) deter-
mined according to EN 62841:
Vibration emission value a
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
Model Capacity
WA3551 2.0Ah
WA3551.1 2.0Ah
WA3880 2.0A
77 dB(A)
3.0 dB(A)
90 dB(A)
3.0 dB(A)
< 2.5 m/s²
h
EN
9