Worx WG260E Mode D'emploi page 10

And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.e personnel can
assist you and offer advice.
4.INTENDED USE
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
5.OPERATING
10
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Handle screws should be
facing the protective shield. If the
handle is assembled incorrectly, the
tool will not power on.
Installing and Removing the battery
pack
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual.
Cordless Hedge Trimmer
OPERATION
Starting and stopping
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until
all damaged parts have been replaced
or repaired. Failure to do so could
result in serious personal injury. DO
NOT USE WITHOUT FRONT HANDLE
AND SAFETY GUARD.
Side cutting
Lubricating the Cutting Blade
NOTE: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be activated
on three sides, giving you many choices for a
comfortable grip. Before cutting an area, inspect
it first and remove any foreign objects that could
become thrown or entangled in the blades. Always
hold the trimmer with both hands and with the blade
away from you before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade. (See Fig. E1& E2)
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
FIGURE
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levels (5 & 6) before
See Fig. A
attempting to clear jammed debris from the cutting
blades.
Wear gloves when trimming thorny or prickly growth.
See Fig.
Do not attempt to cut stems that are too thick for the
B1, B2, B3
cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. E1). A slight
downward tilt of the cutting blades in the direction of
See Fig. C
motion gives the best cutting results.
SIDE CUTTING
When trimming the sides of the hedge, begin at the
bottom and cut upwards (See Fig. E2), tapering the
hedge inward at the top. This shape will expose more
of the hedge, resulting in a more uniformed growth.
See Fig.
D1, D2
See Fig.
E1
See Fig.
E2
See Fig. F
EN