Publicité
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left sleep for
more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period, or set whether to enable auto top-
up, emptying and drying, to dim indicator
lights, or lower the volume of the voice
message during the DND period.
Mop Washing
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. To manually start washing,
tap the corresponding button in the app.
Press any button to stop washing.
Notes:
• To ensure the robot automatically washes the mop
cloths, start it from the dock and avoid moving the
dock during cleaning.
• Mop wash frequency and mode can be modified in the app.
Emptying
After cleaning, the robot will return to
the dock and auto-emptying will begin
as needed. To manually start emptying,
press
on the docked robot or tap the
corresponding button in the app. Press any
button to stop emptying.
Notes:
• When emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto-emptying can be disabled in the app.
• Avoid frequent manual emptying.
• Do not use without dust container cover or disposable
dust bag installed in place.
Drying
After mop washing or after cleaning, drying
will begin as needed. To manually start or
stop drying, tap the corresponding button
in the app.
Notes:
• Drying duration can be modified in the app.
• Auto-drying can be disabled in the app.
Charging
After cleaning, the robot will automatically
return to the dock to charge. Press
the paused robot back to the dock. The power
indicator light will breathe during robot charging.
Note:
If the robot fails to find the dock, it will automatically
return to its starting position. Place the robot on the dock
manually to recharge.
008
Error
If an error occurs, the power indicator light
will flash red or status indicator light will be
steady red. A pop-up notification will appear
in the app and a voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
If the robot does not respond when a button
is pressed or cannot be turned off, reset the
system by pressing the Reset button.
Note:
After resetting the system, existing settings such as
scheduled cleaning and WiFi will be restored to factory settings.
Deactivating WiFi
To disconnect the robot from WiFi, press
the Reset button until you hear a voice
message. Then wait for 5 minutes and the
WiFi will be automatically deactivated. If you
want to reconnect, please follow the related
connecting instructions.
Restoring Factory Settings
to send
If the robot does not function properly after
a system reset, power it on. Press and hold
and at the same time, press the Reset
button until you hear the "Restoring factory
settings. This will take about 5 minutes."
voice message. The robot will then be
restored to factory settings.
Publicité
