Cata IAS 6024 Manuel D'instructions page 59

EN
PROBLEM POSSIBLE CAUSES
"ıı" fixed, controls
Pause Function activated via the
do not respond
Function / Pause Key (F) "
"ıı" flashes when
Memory Function activation.
switching on
"dE", the hob does
Demo Mode is active.
not heat
Zones do not reach 1. Unsuitable pan.
sufficient 2. Power limitation active.
temperature 3. Low mains voltage.
Power in one zone System power limit reached.
drops when another
is increased
A zone switches off
Maximum operating time exceeded. Refer to the "Automatic Safety Switch-off"
by itself
Normal operating sounds.
Noises heard when
hob is on or off
Automatic odour elimination.
Fan continues after
hob is switched off
Spill occurred in the Accidental spill during cooking.
extraction area
1. Dirty filters.
Reduced extraction
power 2. Obstruction in grilles or ducts.
SOLUTION
Refer to the "Pause Function" section.
".
Refer to the "Memory Function" section.
Refer to the "Demo Mode" section and deactivate
it as instructed.
1. Try another pan.
2. Refer to "Power Limitation Function".
3. Check mains voltage and connection (see
FIG.1).
Use a lid for improved efficiency.
Use zones on opposite sides (left/right) to allow
greater simultaneous power.
section and reactivate the zone.
Refer to the "Noises" section. If there are no error
messages, it is not a fault.
The fan switches off automatically after a few
minutes. It can be switched off manually using the
On/Off Key (B) "
recommended.
Clean the extraction system components (see
FIG.9). In recirculating installations, also check the
odour filters.
1. Clean the filters (see FIG.9).
2. Check for objects blocking air inlets or outlets.
", although this is not
USE
59