Demo Mode; Using Your Induction Hob - Cata Ias 6024 Manuel D'instructions

EN
From this point onwards, the hob will be configured with the selected power limit. This may increase the time required
to heat and cook food, as well as limit the number of cooking zones and levels that can be used simultaneously.
If you exit the configuration without saving, the setting will not be retained. The power limit can be changed again by
repeating the process from step 1.

Demo mode

This setting allows the retailer to showcase the full operation of the hob without heating cookware, preventing accidents
during product display. This function is disabled by default and can be enabled using the following procedure:
To start configuration, the appliance must be switched off and there must be no pans on the cooking zones
1. Disconnect the hob from the power supply for 20 seconds and reconnect it. This setting can only be performed
within 2 minutes of reconnection.
2. With the control off, press and hold the on/off key (B) "
and the key must remain pressed until the 10 seconds elapse. At this point, the timer digit (d-T) will flash,
displaying the current configuration:
• "00" – Demo mode disabled
• "dE" – Demo mode enabled
3. The demonstration mode can be enabled or disabled by pressing the timer key (D) "
4. Once the desired configuration is selected, press the on/off key (B) "
From this point onwards, the hob will be configured with the enabled or disabled Demo mode according to the selection
made. The mode can be changed again by repeating the process from step 1.
With Demo mode enabled, the timer digit (d-T) will display "dE" while the hob is in use, and the cooking zones will not
heat any cookware.

USING YOUR INDUCTION HOB

Warning: Individuals with pacemakers should consult their physician before using any induction hob.
Built-in Assistance and Safety Functions
The hob features a number of automatic functions to facilitate use and ensure safety:
• Automatic Pan Detection: When a suitably sized and compatible cookware item is placed on a cooking zone,
the zone is automatically activated, allowing the desired power level to be selected. If multiple zones are
occupied when the hob is switched on, they will be sequentially activated for adjustment.
• Unsuitable Object Detection: If an attempt is made to heat a zone with incompatible cookware or a small
object (such as a knife, fork, or key), the zone will not heat and the empty zone indicator
the display.
• Automatic Switch-off for Empty Cooking Zones: If the cookware is not returned, the cooking zone will
automatically switch off after 30 seconds. Upon removing the pot, the hob stops heating immediately and the
empty zone indicator
seconds.
• Automatic Safety Switch-off: To prevent accidents due to inattention, the hob automatically switches off any
cooking zones that have been left on for too long. Maximum operating times depend on the power level as
shown in the table below:
appears on the display. If no pan is replaced, the zone shuts off automatically after 30
Power Level
Max. Default Operating
Time (min)
" for 10 seconds. During this time, the hob will turn on,
1-3 4-7
180
360 120
".
" again to save the setting and exit.
will be shown on
9
90
USE
53