Booster Function; Cooking Functions; Bridge Function - Cata Ias 6024 Manuel D'instructions

EN

Booster Function

The Booster Function quickly heats a cooking zone for a limited time of 5 minutes, after which the power drops to level
"9". To activate it, press the Boost control key (E) "
cancel, activate the zone and select a different power level.
AUTO Cooking Function
This function applies reinforced power for a set time to speed up heating until the selected power level is reached.
Selected Power Level
1
2
3
4
5
6
7
8
9
To activate for a working cooking zone:
1. Select the desired power level via the Power sliding control (J) "
2. The zone digit will alternate between the selected level and "A" while active.
3. The Timer digit (d-T) will show the remaining time.
4. Once finished, the zone maintains the selected power level.
To cancel, activate the zone and select a new power level.
Cannot select automatic boost if power level 9 is selected.

Cooking Functions

This function maintains a stable temperature range in a cooking zone. Three levels are available:
• "- -": 42±5ºC
• "==": 70±5ºC
• "≡≡": 90±5ºC
To use it, activate a zone and press the Cooking functions / Pause key (F) "
cancel, press the key again until "0" is shown or select a new power level. If the zone operates continuously in a cooking
function, it will switch off after 360 minutes.

Bridge Function

The flexible cooking zones allow the Bridge function, which combines two adjacent zones to operate as one larger
zone with a shared power level. This enables uniform heating for large cookware.
Each front cooking zone can be bridged with its corresponding rear zone.
To activate this function:
1. Press and hold the Cooking Zone Selection Buttons (A) "
until both digits blink simultaneously.
2. Select the desired power level, which will be shown on both displays.
To adjust the power of a bridged zone, simply select either of the two zones: both digits will activate simultaneously.
Zones remain bridged until the hob is switched off or the Bridge function is deactivated by repeating the steps above
B
" while the zone is active. The display shows "P". To
Reinforced Power Time
00:45
02:20
03:45
05:10
06:45
02:00
02:45
03:40
-
" and hold for 3 seconds.
" until the desired range is selected. To
" on the right or left side for 3 seconds,
USE
55