Cata IAS 6024 Manuel D'instructions page 58

EN
Odour Filter Maintenance Alert
After 150 hours of use, if the hob is set to recirculation mode, the Timer Display (d-T) will show "CF", indicating
that the odour filters need maintenance (follow the specific instructions provided by the manufacturer).
Once completed, reset the alert by pressing the Power/Time Increase Button (I) "
Pause Button (F) "
TROUBLESHOOTING
If the hob is not functioning correctly, consult the following table. In most cases, these issues can be easily
resolved without contacting the After-Sales Service.
Problems that do not prevent the use of the hob
PROBLEM
Control keys are
not responding
The symbol
flashes alternately
with the power
level
"H" appears on the
zone display
"SL" appears when
pressing a function
"IF" appears
"CF" appears
"LL" appears and
controls do not
respond
"LO" appears and
controls do not
respond
58
" simultaneously.
POSSIBLE CAUSES
1. Power supply failure.
2. Touch control used
incorrectly.
No pan on the selected zone or
unsuitable pan.
The switched-off zone is still
hot.
A cooking zone has not
been selected first.
Grease filter maintenance
warning.
Activated carbon filter maintenance
warning.
Control lock is active.
Safety lock is active.
" and the Cooking Functions /
SOLUTION
1. Check that the appliance is correctly connected
(see FIG.1).
2. Do not use gloves and press the key fully with
your finger.
If the issue persists, contact the After-Sales Service.
Place a suitable pan on the selected zone.
Risk of burns! Do not touch the glass until the
symbol disappears.
First select a cooking zone, then apply the
desired function.
Refer to the "Grease Filter Cleaning Alert" section.
Refer to the "Odour Filter Cleaning Alert" section. (If
your installation is not recirculating, see "Extraction /
Recirculation Mode Selection").
Refer to the "Control Lock" section.
Refer to the "Safety Lock" section.
USE