Power Management - Cata Ias 6024 Manuel D'instructions

EN
INITIAL START-UP / INSTALLATION CONFIGURATION
Important: Before using the appliance, ensure it is configured according to your needs.
Selecting extraction / recirculation mode
Depending on the desired installation, the appliance can be set to extraction mode or recirculation mode. By default, the
appliance is configured in extraction mode. If installation in recirculation mode is required, follow the procedure below:
Para iniciar la configuración, el dispositivo debe estar apagado y no tener ningún utensilio en las zonas de cocción. To
start configuration, the appliance must be switched off and there must be no pans on the cooking zones.
1. Press the on/off key (B) "
not select any cooking zone or fan.
2. Press the Boost control key (E) " B " for 2 seconds. The d-T digit will show the current installation type:
• "==" - "==" - Extraction mode
• "≡≡" - Recirculation mode
3. Press the power/time increase key (I) "
Once the installation type is selected, press the Boost contro Bl key (E) " B " to save the setting and exit.
4.
From this point onwards, the hob will be configured with the selected installation mode.
If you exit the configuration without saving, the setting will not be retained. The installation mode can be changed
again by repeating the process from step 1.
The recirculation mode adjusts the fan suction power levels and enables the odour filter warning alarm. When the hob is
turned off, the fan continues to operate for a few minutes to ensure air purification, odour elimination, and drying of the
filters and installation. If desired, the fan can be stopped by pressing the on/off key (B) "

Power management

By default, the appliance is set to maximum power. If the available power supply is lower than required, the maximum
power consumption can be reduced according to the following table:
To start configuration, the appliance must be switched off and there must be no pans on the cooking zones.
1. Press the on/off key (B) "
Do not select any cooking zone or fan.
2. Press the power/time reduction key (H) "
seconds. The d-FL digit will display "5".
3. Press the Power/time reduction key(H)"
4. Press the power/time reduction key (H) "
FL and d-FR digits will show the current maximum power according to the table above.
5. Press the cooking functions /pause key (F) "
6. Once the desired maximum power is displayed, press the power/time increase key (I) "
and exit.
52
" to switch on the induction hob. The buzzer will beep, and all digits will display "0". Do
d-FL Digit d-FR Digit Maximum Power Consumption (W)
1 5
2 8
3 3
4 5
5 7
7 4
" to switch on the induction hob. The buzzer will beep, and all digits will display "0".
" to change the mode.
1500
2800
3300
4500
5700
7400
" and the power/time increase key (I) "
". The d-FL digit will display "5", and the d-FR digit will display "E".
" and the power/time increase key (I) "
" to select the desired maximum power according to the table.
", but this is not recommended.
" simultaneously for 2
" simultaneously. The d-
" to save the setting
USE