Beko FBS63121WD Manuel D'utilisation page 34

5. If the gas is not ignited after pressing on
and releasing the knob, repeat the same
process by pressing on the knob for 15
seconds.
Release the button if the burner is
not ignited within 15 seconds. Wait
at least 1 minute before trying
again. There is the risk of gas accu-
mulation and explosion!
6. Adjust your desired power level.
Turning off the gas burners
Bring the burner knob to off position (top).
If the flames of the burner are extin-
guished inadvertently, turn off the
burner control knob. Do not attempt
to ignite the burner again for 1
minute at least.
Gas shut-off safety mechanism
As a precaution against blow out due to
overflows over the top burners, a safety
mechanism starts to operate and shuts off
the gas immediately.
1 Gas shut off safety
To activate the gas shut-off safety mechan-
ism, keep the control knob pressed for 3-5
seconds more after igniting the hob.
Using the hotplate(s)
You may operate the hotplate(s) with hob
control knob(s). Each knob operates the re-
spective hotplate. You may infer which hot-
plate it controls from the symbols on the
control panel.
When turned off (top position), the hotplate
does not operate. Set your desired cooking
level by aligning the knob to the respective
levels.
The hob(s) may have different operating
levels as per the model of your appliance.
You may select the relevant level for your
cooking type by referring to the table be-
low.
6 levels:
1 : Heating
2 – 3 : Boiling, Resting
4 – 6 : Baking, Frying, Boiling
If there are hotplates with quick
heating feature, these are marked
with a red dot.
Overheating protection
Hobs with a power above 1000 W are
equipped with overheating protection. Over-
heating protection reduces the power of the
hotplate in the following conditions:
• No pots or vessels on the hotplate.
• Empty pot or vessel on the hotplate.
• The fact that the base of the pot or ves-
sel is not flat.
EN / 34
EN
FR