Placing The Product - Beko Fbs63121Wd Manuel D'utilisation

Gas connection is made at the back
of the appliance, Make sure the pip-
ing does not come into contact
with other parts of the appliance,
and that it does not pass through a
space that is cluttered or in contact
with another moving part.
Gas connection
Your product comes with a kit gas connec-
tion, consisting of:
• 2 washers
• 1 adapter
• 1 Butane nozzle
• 1 Natural gas nozzle
According to the gas you use and the type
of pipe, observe the following configura-
tions. Interposer joints as shown on the
drawing.
A. For Butane / Propane gas connection
with a hose clamp and is on the tip Butane,
which is set on the adapter, which in turn
attaches to the stove (Figure A).
B. The connection "mechanical" is flexible
with the adapter, which is itself fixed on the
oven (Figure B).
The butane end piece allows connection
using flexible rubber hosing with 6 mm in-
ternal diameter suitable for bottle gas.
The end piece for piped gas allows con-
nection by bendy piping of 15 mm internal
diameter, such piping being strengthened
so that it can be mandatorily held in place
by a locking collar. Use piping carrying the
NF-GAZ stamp. This piping is regularly to
be replaced before its use expiry date.
Do not use a lighter or a match to
check for a gas leak.
Checking seal-tightness : Make
sure that all knobs on the stove are
in the off position and the gas
bottle connection is open. Use soap
to check for any gas leaks. Any leak
will cause the soap to bubble. If
this happens, check the gas con-
nection again.
Using a cooking appliance with
piped gas leads to heat and humid-
ity being produced in the area
where the appliance is installed.
Make sure there is good ventilation
in the space where the appliance is
installed. Keep all natural ventila-
tion apertures open, or install a
mechanical ventilation device such
as an extraction hood. Prolonged or
intensive use of the appliance may
call for additional ventilation such
as opening windows, or for more
effective ventilation by increasing
the power of the extraction hood if
any.

4.4 Placing the product

1. Push the product towards the kitchen
wall.
2. Secure the safety chain you have con-
nected to the product to the wall.
3. Adjust the feet of oven
Adjusting the feet of oven
Vibrations during use may cause cooking
vessels to move. This dangerous situation
can be avoided if the product is level and
balanced.
For your own safety please ensure the
product is level by adjusting the four feet at
the bottom by turning left or right and align
level with the work top.
Final check
1. Reconnect the product to the mains.
2. Check electrical functions.
3. Open gas supply.
EN / 29
EN
FR