Beko FBS63121WD Manuel D'utilisation page 26

• If you do not make the connection ac-
cording to the instructions below, there
will be the risk of gas leakage and fire.
Our company cannot be held responsible
for damages resulting from this.
• Gas connection must be made by an au-
thorised/licensed/ qualified person or
technician only.
• Make sure that the gas hose to be used
in the gas connection complies with the
local gas standards.
• The flexible gas hose must be connected
in a way that it does not contact the mov-
ing parts and hot surfaces (shown below
figures) around it and is not trapped
when the moving parts are travelling.
(e.g. drawers). Besides, it should not be
placed in spaces where it might get
squeezed.
• Do not move the product whose gas con-
nection is complete. If it is moved, there
may be a risk of gas leakage.
• A spanner must be used for gas connec-
tion and conversion.
Gas connection hose placement
• The gas hose should be connected by
making wide-angle turns against the pos-
sibility of breaking and folding during the
connection.
• Before gas connection, make sure that
the gas main supply and the gas hose
outlet of the product to be connected to
the gas is on the same side.
• The gas hose should not be crushed, fol-
ded, pinched or come into contact with
sharp corners or cookware utensils on
the product. There is a risk of explosion
due to damage to the gas hose!
Parts for Gas Connection
The parts and tools visuals, may be re-
quired for the gas connection are given be-
low. Depending on the model, these parts
may not be given with the product. The gas
connections parts to be used may vary ac-
cording to the gas type and country regula-
tions.
Leakage Seal :
Connection piece EN 10226 R1/2" :
Connection piece for liquid gas (G30,G31) :
Gas outlet connection piece :
Making the gas connection - NG
• Natural gas installation must be prepared
suitably for the assembly before in-
stalling the product. There must be a nat-
ural gas valve at the outlet of gas system
to be connected to the product.
• Make sure that the natural gas valve is
readily accessible.
EN / 26
EN
FR