Activating The Remote Control - Dirt Devil NAVIGATOR M608-0 Mode D'emploi

3 Prior to first use
11

3.5 Activating the remote control

12
3.6 Inserting batteries into the light fence tower
13
44
5. Now charge your robot for approx. 4 to 5
hours, until
- a short tune is played and
- both LEDs turn off (Fig. 11).
NOTE:
When its battery capacity becomes low,
your robot automatically returns to the
docking station for charging. If it - for any
reason - does not succeed in docking onto
the docking station, you need to lift it manu-
ally onto the docking station, as described
above.
1. Remove the plastic film (Fig. 12) from the
remote control's battery compartment.
1. Open the battery compartment cover.
2. Insert the 2 supplied batteries (type C,
1.5 V) as indicated (Fig. 13). Make sure
you position them correctly (Fig. 13).
NOTE:
When changing batteries, be sure not to
mix batteries of different types or those that
are fully charged with those that are partly
charged.