Use; How To Vacuum - Dirt Devil NAVIGATOR M608-0 Mode D'emploi

5 Use

5.1 How to vacuum

5 Use
WARNING:
Danger of injury! You can let your robot run
unsupervised, however always be careful
not to step on it, this could cause you to fall.
A
14
15
46
Go
1
2
3
4
CAUTION:
Although your robot recognises drop-offs,
we strongly advise against using it on furni-
ture. It is not suitable for this type of use.
1. Turn on the cleaning robot. To do this, ei-
ther press the robot's "On/Off" key (
for more than 1 second or press the "
key on the remote control.
- A short beep occurs.
- Both LEDs are lit.
2. Press the robot's "On/Off" key (
Go
" " key on the remote control shortly to
start the robot.
- A tune is played.
- The red LED turns off. The blue LED is
still lit.
- Your robot starts in power mode;
- if you want to adapt the cleaning rate,
see Chapter 5.2, "Switching between
power or silent mode".
- Based on certain conditions such as the
underlying surface, room geometry, ob-
stacles and so on your robot will switch
modes (Fig. 15/1 to 4) to achieve opti-
mum efficiency.
NOTE:
Alternatively, you can activate the mode
you prefer via remote control. Just press
one of the following keys: "
" ".
Note that best cleaning
achieved, if your robot combines all 4
modes automatically.
)
"
) or the
", " ",
results are