Changing The Remote Control's Battery - Dirt Devil NAVIGATOR M608-0 Mode D'emploi

7 Troubleshooting
7.4 Changing the side brush
34

7.5 Changing the remote control's battery

+
35
7.6 Changing the light fence tower's batteries
Chapter 3.6, "Inserting batteries into the light fence tower"
7.7 If the appliance is defective
WARNING:
Danger of injury! Never use or charge a defective appliance! If the robot or power cord of the AC
adapter is damaged, it must be replaced by the manufacturer, the manufacturer's customer ser-
vice or a similarly qualified person, in order to avoid danger.
If the appliance has been dropped or damaged in another way and has obvious signs of damage,
have it repaired by an authorised dealer or contact the Dirt Devil Customer Service.
Send the defective appliance with emptied dust bin to the address on
vice'.
1. Ensure that the appliance is switched off
(no LED is lit).
2. Pull off the side brush (Fig. 34).
3. Install the new side brush. It will audibly
snap into place.
1. Open the remote control's battery com-
partment (Fig. 35). It is advisable to use a
small coin to ease this operation.
2. Substitute the worn out CR2025 cell with a
new one. Pay attention to correct polarity
(Fig. 35).
3. Dispose of the worn out cell at your local
recycling points. Keep these batteries
away from children!
Page 202, 'International Ser-
57