Publicité
Hose nozzle will
not spray after
filling the clean
water tank.
Motor noise
becomes high-
pitched.
Speed Button
flashes red
light and then
turns off when
using the spot
cleaner.
TROUBLESHOOTING
Air is trapped in the
pump and hose.
Dirty water tank is full.
The suction hose is
clogged.
The float in the dirty
water tank has been
activated.
The motor is protected.
The motor is damaged.
Turn on the spot cleaner. If hose
does not spray, prime the pump
by lowering the hose down to the
floor and hold the trigger for up to
1 minute.
Empty the dirty water tank.
Clean the hose.
Empty and clean the dirty water
tank.
Empty the dirty water tank and
restart the spot cleaner. Once the
dirty water tank is full, turn off the
spot cleaner and empty the dirty
water tank in time.
Call 1-877-531-7321 (US) / 1-844-
608-3081 (CA) for assistance.
- 23 -
Publicité
