Publicité
IMPORTANT!
the spot cleaner, thoroughly
vacuum the area to be cleaned.
Always test a small hidden
area for colorfastness and pile
distortion.
Test Colorfastness - Gently
rub surface with a dampened
white cloth containing cleaning
solution. Wait 10 minutes and
check for color removal with
a white paper towel. If color
changes, do not use.
NOTE:
To prevent staining,
use plastic or aluminum foil to
protect wood or metal surfaces
from possible water spray.
To protect the wood floors
underneath rugs or carpet, place
waterproof material (e.g. plastic)
underneath them before cleaning.
NOTE:
Always refer to and
follow the manufactures care
guidelines before using cleaning
solution and spot cleaner.
1. Unwrap the hose from the
unit. Make sure the tough stain
nozzle is attached securely.
NOTE:
The tough stain nozzle
can be used for cleaning carpet
stains, furniture and other hard-
to-reach surfaces.
2. Press the power button to turn
the spot cleaner on. The spot
cleaner starts in normal speed
mode by default.
USING THE SPOT CLEANER
Before using
3. Select the desired cleaning
mode by pressing the speed
button. Pressing the speed
button will switch the spot
cleaner into: Normal Speed
Mode
Normal Speed Mode.
For ordinary stains, select the
Normal Speed Mode. The speed
button will glow a steady green
light to indicate the status.
For stubborn stains, select the
High Speed Mode. The speed
button will glow a steady orange
light to indicate the status.
4. Hold the tool about 1 inch
over the stain to be cleaned.
Squeeze the spray trigger to
spray a generous amount of
cleaning solution over the
soiled area. Use the brush on
the tool to agitate stains by
scrubbing in a back and forth
motion.
- 14 -
High Speed Mode
Publicité
