Publicité
EMPTYING THE DIRTY WATER TANK
WARNING
Always disconnect the battery
pack from the spot cleaner
before performing any service
on spot cleaner.
Empty the dirty water tank
when the dirty liquid reaches the
"Max Fill" line and there is a loss
in suction. During normal use,
debris may accumulate in the
dirty water tank. In order to keep
the spot cleaner functioning
properly, rinse out the dirty water
tank with clean water after each
use.
1. Lift up the dirty water tank
from the side of the unit. A
security latch is positioned to
keep the dirty water tank in
position to avoid unintentional
release. The latch will
automatically release when the
tank is pulled upwards.
2. Remove the dirty water tank
3. Empty the tank into a sink
4. Insert the locking tabs into the
Security
Latch
- 16 -
cover by undoing the dirty
water tank cover release.
or toilet. Rinse the tank
thoroughly with clean water.
If continuing to use after
emptying the dirty water tank,
be sure to dry the outside of
the tank before reinstalling.
slots of the dirty water tank
first and then secure the dirty
water tank cover back into
place until a click is heard.
Publicité
