BH FITNESS G2530O Instructions De Montage Et Utilisation page 16

Fig.1 Parts list.
(111) Electronic monitor.
(8) Monitor support.
(5L) Left-hand monitor support cover.
(5R) Right-hand monitor support cover.
(12B) Rear post spindle cover.
(12F) Front post spindle cover.
(13L) Top focus bar, left.
(13R) Top focus baronta, right.
(19L) Left focus bar or arm.
(19R) Right focus bar or arm.
(20L) 2 Focus bar spindle covers (L).
(20R) 2 Focus bar spindle covers (R).
(43L) Pedal left foot.
(43R) Pedal right foot.
(48L) Left footrest .
(48R) Right footrest.
(72) Main body.
(75) Rear stabiliser
adjustable feet.
(93) Top cover.
(94) Front stabiliser bar with wheels.
(116) Main post.
(103) Focus bar spindle.
(104F) Rear central post cover.
(104B) Front central post cover.
Fig.2 Screws and fasteners.
(6) Screws M-5x10.
(7) Screws M-4x15.
(11) Washers Ø 17 Ø 25.
(16) Screws M-8x20.
(17) Spring washer M-8.
(18) Washers M-8 Ø 28.
(21) Allen screws M-10x78.
(27) Washers M-10.
(28) Self locking nuts M-10.
(44) Flat washers M-6.
(45) Spring washer M-6.
(47) Screws DIN 603 M-6x50.
(50) Washers M-8 Ø 21.
(77) Screws DIN 603 M-8x110.
(84) Screws M-5x15.
(91) Self locking nuts M-8.
(92) Corrugated washer 8x19.
(97) Washers M-8 Ø 19.
(99) Screws Allen M-8x20.
(107) Screws M-5x20.
Combination box spanners.
Allen key.
2. FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
First, lift the front of the machine and
rest it on a prop, such as the
packaging that you have just removed.
Bring the front stabiliser bar with
wheels (94) to the main body (72)
positioning the wheels at the front of
the unit, Fig.3, insert the screws (77),
bar with fit the flat washers (92-17) and self
locking nuts (91), and tighten securely.
Carry out the same operation to attach
the rear stabiliser bar. Lift the rear of
the machine slightly and rest it on a
prop, such as the packaging that you
have just removed.
Take the rear stabiliser with adjustable
feet (75), and line up the dots, Fig.3.
Insert the screws (77), fit the washers
(92-17) and nuts (91), and tighten
securely.
Place the top cover (93).
3. FITTING THE MAIN POST.-
Take the main post (116) and remove
the
washers (92) and spring washers (17)
from the bottom of the post. Fig.4A.
Bring the main post (116) up to boss
on the main body (72), Fig.4.
Take the tip of the tension cable (112),
sticking out of the bottom of the main
post (116) and connect it to the tension
support (115), as shown in Fig.4B.
16
screws (99) the corrugated