Structure; Attaching The Racket For Stringing - Pro's Pro Phoenix-2 Manuel D'instructions

Operating instructions
for
pro's pro® PHOENIX-2

Structure

Take the support leg and the tool tray from the first box and the H-foot from the second box and connect the parts together (the required
screws are already in the parts). Now insert the machine with the turntable from above into the opening of the support leg and fix it
laterally with the Allen screw so that the machine is firmly mounted.
•
Insert the handle for the crank pull system into the opening provided.
•
The two retaining clamps must then be inserted into the bases and the 4 frame fixings inserted into the fixing holes provided
and secured from below with the corresponding screw. When stringing tennis rackets, the longer side must face inwards
(towards the racket) / When stringing badminton rackets, the shorter side must be turned inwards.

Attaching the racket for stringing

Step 1 Loosen the locking screw on both supports by turning them to the left. Carefully place the racket on the support arms. Position the
supports so that they are fixed in the center of the turntable with the locking screws. Never use excessive force when doing this! Check
that the two holding clamps reach the entire area of the frame.
Step 2. Turnthe fine adjustment screws on the support arms to fix the racquet - do not overtighten !
Step 3. Tighten the locking screws on the supports on the underside of the turntable
Step 4. Usethe fine adjustment screws of the heart head fixation to align the club evenly and bring it slightly under tension. Only use
your index finger and thumb!
.
This illustration shows the assembly for stringing tennis rackets.
The two heart head fixings must be rotated by 180°. To do this, open
the screw on the side, pull out the fixings and refit them rotated.
page 6 from 11